rcFoamFighters - Foam Fighter 22 (FF-22)

FF-22 (Foam Fighter 22) - Information and Plans
Picture		Sponsor Ad

FF-22 RC Model Designed by: Paul Petty This RC model is loosely based on the F-22 Raptor used by the USAF. The original RC model design was made with Elmers Foamboard and covered with colored sealing/packing tape. Other materials such as Depron and Fan Fold Foam may be used to make this model.
Free Tiled PDF Plan	Free Non-Tiled PDF Plan
	Non-Tiled PDF is not Available at this time
	All plans are free, but if you would like to directly support and encourage the Model Designer, donations are welcome. That or if you just want to buy the designer a beer, or more like a late night coffee, thats cool too...LOL. Any help to support the rcFoamFighters team and their efforts is greatly appreciated.
BASIC RC MODEL NOTES: Wing Span: 24 Inches (60.96cm) Length: 42.5 Inches (107.95cm) AUW: 29 Ounces (822gm) (As Built with FoamBoard, Depron or Fan Fold will result in much lighter model) Servos: 3 Micro (Metal Gear Recommended) Motor: 2212/6 for Basic Setup (Grayson Hobbies Super Mega Jet for Performance Setup) Speed: 50mph to 70+mph (80.5kph to 112kph) depending on motor used Required Radio: Minimum 4-Channel (Recomended 6 channel 2.4ghz) Flight Skill Required: Intermediate to Advanced Building Skill Required: Beginner to Intermediate

Parts And Equipment Ideas For This Model			Sponsor Ad
Brushless Motors
Combo Pack, ESC included!	TURNIGY 2836-2350 Note, Motor shaft must be reversed to use this motor.	Combo Pack, ESC included!
Brushless ESC's (With BEC)
TURNIGY 40A Plush	TURNIGY 40A K-Force
Lipo Batteries
TURNIGY 2200 3S 30c	Rhino 2150 3S 30c
Servos
Hextronik MG Servo	Corona MG Servo
Radios and Tape