MX-1 Wolverine - Information and Plans
Picture Sponsor Ad
MX-1

Link to HobbyKing.com

MX-1 Wolverine RC Model Designed by: Jake Marshall
This RC model is a completely original design by Jake. Jake wanted to create a plane with a look and feel of a fierce Wolverine. The original RC model design was made with Foamboard and covered with colored sealing/packing tape. Other materials such as Depron and Fan Fold Foam may be used to make this model.
Free Tiled PDF Plan Free Non-Tiled PDF Plan
Link to Tiled PDF Plans Non-Tiled PDF is not Available at this time
All plans are free, but if you would like to directly support and encourage the Model Designer, donations are welcome. Any help to support the rcFoamFighters team and their efforts is greatly appreciated.
BASIC RC MODEL NOTES:
  1. Wing Span: 29 Inches (86.36cm)
  2. Length: 30.56 Inches (90.68cm)
  3. AUW: 25 Ounces (708.75gm) (As Built with FoamBoard, Depron or Fan Fold will result in much lighter model)
  4. Servos: 2 Micro (Metal Gear Recommended)
  5. Motor: 2212/6 for Basic Setup (Grayson Hobbies Super Mega Jet for Performance Setup)
  6. Speed: 50mph to 70+mph (80.5kph to 112kph) depending on motor used
  7. Required Radio: Minimum 4-Channel (Recomended 2.4ghz)
  8. Flight Skill Required: Intermediate to Advanced
  9. Building Skill Required: Beginner to Intermediate
Parts And Equipment Ideas For This Model Sponsor Ad
Brushless Motors

Link to rcSkyFlyer.com

Combo Pack, ESC included! 		Link to Motor
TURNIGY 2836-2350
Note, Motor shaft must be reversed to use this motor.
Combo Pack, ESC included!
Brushless ESC's (With BEC)
Link to ESC
TURNIGY 40A Plush		 Link to ESC
TURNIGY 40A K-Force
Lipo Batteries

Link to HobbyKing.com
Link to Battery
TURNIGY 2200 3S 30c
Rhino 2150 3S 30c
Servos

Hextronik MG Servo
Corona MG Servo
Radios and Tape

Copyright rcFoamFighters.com 2010